1, Â Â Â Â Â Â Â Â Before driving, check whether the contact part of the belt is in good contact, whether the tightness is suitable, whether the bolts and rollers of each component are in good condition, whether there is any blockage in the feeding and discharging, and timely replacement when the wear is serious. 2, Â Â Â Â Â Â Â Â Check for any debris under the belt, whether the first and last wheels and the roller are muddy, and remove if necessary. 3, Â Â Â Â Â Â Â Â Check the suspension magnet performance is good, it is working properly. 4, Â Â Â Â Â Â Â Â Before driving, you should send a signal to contact the relevant post before you can drive. 5, Â Â Â Â Â Â Â Â It is strictly forbidden to ride, climb, or cross the rotating belt. 6, Â Â Â Â Â Â Â Â When the roller is not turned or lacks oil, it must be replaced and repaired. The belt conveyor in operation must not be inspected, repaired, oiled and cleaned. It is strictly forbidden to touch the roller and the front and rear wheels by hand. 7, Â Â Â Â Â Â Â Â When the machine stops, it should stop the signal and then stop in sequence. 8, Â Â Â Â Â Â Â Â When the belt runs off, it should be treated immediately to prevent tearing the belt. 9, Â Â Â Â Â Â Â Â When the accident stops, the switch should be pulled down immediately. Plate Heat Exchanger,Double Pipe Heat Exchanger,Plate Type Heat Exchanger,Air To Air Heat Exchanger Wuxi Dingfeng pressure vessel Co., Ltd , https://www.wuxidingfeng.com