hot sale water meter multi dry type water meter multi wet water meter single water meter Ningbo Jingcheng Technology Co., Ltd. , https://www.jingchengmeter.com
2. Select a saw blade that meets the cutting requirements. The edge should be sharp.
3. Before starting the machine, check whether the installation of the saw blade is securely installed. The bracket is safe and reliable, and whether the protection connection is in good condition. Check whether the direction of rotation of the cutting blade is correct after each reconnection.
4. The workpiece to be cut should be clamped and fixed. When cutting an angle workpiece, the required angle should be adjusted, fixed and locked.
5, work should be avoided as much as possible to the front of the saw blade operation, it should stand on the left side of the saw blade vertical right 30 ° angle position.
6. The cutting amount (pushing force) should be moderate during the cutting operation. When the knife is fed in, it must be slowly pushed forward to avoid excessive force. When the clamp saw phenomenon occurs, it should be immediately shut down, otherwise the motor load will increase or be burned.
7. The power should be cut off in time when the work is over, and the work site can be left behind after cleaning.
Desktop cutting machine safety operating procedures
1. Organize the job site and arrange the work pieces neatly. The processed parts and the parts to be processed should be placed separately.