Flat packaging bags are a great choice for food packaging, powdered mixes, small products, and flat paper items. These bags could also been in sheet or in roll. With good grade material, nice heat sealing, the bags are water-proof and good for storage.
The packaging bags in roll
Food packaging in sheet
Flat Barrier Bags,Flat Bag On Roll,Flat Bag On Sheet,Side Sealing Flat Bag,Poly Bag Roll,Food For Go Bag BILLION PLASTIC MANUFACTURING CO.,LTD, JIANGMEN , https://www.billion-plastics.com
2, water protection should always check the cleaning, cooling water often can not open the water protection float switch or water protection float switch is not reset, can not use short-circuit method to solve the urgent need.
3. The laser fulcrum of the laser cutting machine must be installed properly. The fulcrum should be at 1/4 of the total length of the laser tube. Otherwise, the spot pattern of the laser tube will be deteriorated. In some jobs, the spot becomes a few points, causing the laser power to drop. Unable to meet the requirements, resulting in continuous change of management,
4, focusing mirror and mirror inspection, work for a frame on the fever, the lens surface discoloration and rust; stripping cracking are the objects to be replaced, especially a lot of customers with atmospheric pumps and air compressors, so in focus Water collects quickly on the lens, so it is necessary to check the cleanliness and quality of the optical system of the lens on time.
5, the suction device should be checked and cleaned on schedule, to clean up the fan duct. Otherwise, a lot of smoke dust can not be discharged, severe and rapid contamination of the lens and laser tube, so that the mechanical and electronic components easily oxidized cause poor contact.
6. Use electric grid power to match.
7, the working environment of the laser cutting machine can not be too harsh, if the ambient temperature is higher than 30 degrees, less than 18 degrees, too much dust, air pollution is severe, so that the machine is severely damaged, the failure rate continues to rise; various electrical accessories in a humid environment It is easy to have problems.
8, the laser tube operating current to be fair, can not be long-term work in the light intensity of 90-100; to fair use of laser energy and laser energy conservation; optical system to clean and accurate, or cause premature aging and rupture of the laser tube, so the laser machine work The time intensity should be adjusted to 50-60%, and then adjust the working speed according to the material.
How to make the laser cutting machine cut out the best effect
1. The cooling system should be grounded, often cleaning the tank and the waterway, the temperature control point of the refrigeration temperature control tank must be fair, otherwise it will cause the laser tube to be easily damaged and the dew condensation power will drop, the cold head of the tube will fall off, the service life will be greatly shortened, and sometimes it will not work. Keep changing tubes.