1) The clearance between the steering knuckle and the knuckle pin shaft should be no more than 0.1mm. 2) The end gap between the steering knuckle and the steering axle is generally 0.05-0.1mm. If the end gap is too large, an adjustment washer can be added for adjustment. 3) Needle bearing between steering knuckle shaft and steering axle, the maximum clearance should be no more than 0.1mm. 4) After the steering axle hub bearing is filled with grease, tighten the hub bearing to adjust the fixing nut. When turning the wheel is difficult, the nut should be returned 1/5 times and the lock washer should be installed. It should be flexible when turning the wheel, and it should be possible to feel the axial gap when the wheel is pulled. 5) Adjust the parallelism of the hub, the error should be no more than 1mm, can be adjusted by adjusting the steering rod screw, and tighten the stop nut after adjustment. 6) Adjust the corner. Lift the steering axle up, turn the hub to the left end position, adjust the steering cylinder piston rod, then pad the spring washer and tighten the nut.
Spray tower Wet Scrubber is mainly used to treat and purify the exhaust gas containing acid mist. It works as follows: The acid mist exhaust gas is introduced into the purification tower through the air duct, passes through the filler layer, and the exhaust gas and the sodium hydroxide absorption liquid undergo gas-liquid two-phase. Full contact with the absorption and neutralization reaction. After the acid mist exhaust gas is purified, it is dewatered and defogged by a demister plate and discharged into the atmosphere by a fan. The absorption liquid is sprayed down on the top of the tower after being pressurized by a pump at the bottom of the tower, and finally returned to the bottom of the tower for recycling. The purified acid mist exhaust gas meets emission standards
Wet Scrubber Dust Scrubber,Wet Scrubber System,Industrial Wet Scrubber,Spray Tower Wet Scrubber Botou Ever Lucky Environmental Protection Machinery Co., LTD , https://www.dustcontrolling.com
Detailed explanation of key elements of assembly and adjustment of forklift steering axle
According to experts, the requirements for the assembly and adjustment of the steering axle of the forklift truck are: after the steering axle is assembled, the parts must have the correct connection and matching clearance.